Estimation of groundwater recharge using the soil moisture budget method and the base-flow model

A detailed characterization of the site is crucial to designing an efficient method of managing the risks associated with tailings from abandoned mines. Therefore, samples collected from various depths within tailings in Guryong mine, Korea, were analyzed for their chemical, physical and mineralogical characteristics. All samples of the Guryong tailings had acid-generating potential. However, in the oxidation zone, the net acid generation (NAG) was low (30 kg H₂SO₄ t⁻¹) although the acid neutralization potential (ANP) was less than zero. The ANP values in the unoxidation zone were higher (> −56.0 kg CaCO₃ t⁻¹) than in the other zones. As a result, the amount of alkali ions that are needed to neutralize the acid needs to be considered. In this experiment G3, G4 and G6 drill cores containing fine tailings particles near the unoxidation zone were observed to contain calcite (CaCO₃) with acid-neutralizing capacity. A low pH (2−4) in the oxidation zone of the tailings changed to a neutral pH in the unoxidation zone of the tailings. These results suggest that the acid-neutralizing capacity of the tailings was controlled by particle and mineral composition of tailings.     

Response of groundwater chemistry to water deliveries in the lower reaches of Tarim River,Northwest China

In this paper, we analysed the monitored data from nine groundwater-monitoring transects in the lower reaches of Tarim River during the five times of stream water deliveries to the river transect where the stream flow ceased. The results showed that the groundwater depth in the lower reaches of Tarim River rose from −9.30 m before the conveyances to −8.17 and −6.50 m after the first and second conveyances, −5.81 and −6.00 m after the third and fourth the conveyance, and −4.73 m after the fifth. The horizontal extent of groundwater recharge was gradually enlarged along both sides of the channel of conveyance, i.e., from 250 m in width after the first conveyance to 1,050 m away from the channel after the fourth delivery. With the rising groundwater level, the concentrations of major anions Cl⁻, SO₄²⁻ and cations Ca²⁺, Mg²⁺, Na⁺, as well as total dissolved solids (TDS) in groundwater underwent a significant change. The spatial variations in groundwater chemistry indicated that the groundwater chemistry at the transect near Daxihaizi Reservoir changed earlier than that farther from it. In the same transect, the chemical variations were earlier in the monitoring well close to watercourse than that farther away from the stream. In general, the concentration of the major ions and TDS at each monitoring well increased remarkably when the water delivery started, and decreased with the continued water delivery, and then increased once again at the end of the study period. Hence, the whole study period may be divided into three stages: the initial stage, the intermediate stage and the later stage. According to the three stages of groundwater chemistry reaction to water delivery and the relationships between groundwater chemical properties and groundwater depths, we educe that under the situation of water delivery, the optimum groundwater depth in the lower reaches of the Tarim River should be −5 m.     

Numerical modeling of rainstorm-induced shallow landslides in saturated and unsaturated soils

For the assessment of shallow landslides triggered by rainfall, the physically based model coupling the infinite slope stability analysis with the hydrological modeling in nearly saturated soil has commonly been used due to its simplicity. However, in that model the rainfall infiltration in unsaturated soil could not be reliably simulated because a linear diffusion-type Richards’ equation rather than the complete Richards’ equation was used. In addition, the effect of matric suction on the shear strength of soil was not actually considered. Therefore, except the shallow landslide in saturated soil due to groundwater table rise, the shallow landslide induced by the loss in unsaturated shear strength due to the dissipation of matric suction could not be reliably assessed. In this study, a physically based model capable of assessing shallow landslides in variably saturated soils is developed by adopting the complete Richards’ equation with the effect of slope angle in the rainfall infiltration modeling and using the extended Mohr–Coulomb failure criterion to describe the unsaturated shear strength in the soil failure modeling. The influence of rainfall intensity and duration on shallow landslide is investigated using the developed model. The result shows that the rainfall intensity and duration seem to have similar influence on shallow landslides respectively triggered by the increase of positive pore water pressure in saturated soil and induced by the dissipation of matric suction in unsaturated soil. The rainfall duration threshold decreases with the increase in rainfall intensity, but remains constant for large rainfall intensity.     

Shear strength characterization of municipal solid waste at the Suzhou landfill, China

The current practice of slope stability analysis for a municipal solid waste (MSW) landfill usually overlooks the dependence of waste properties on the fill age or embedment depth. Changes in shear strength of MSW as a function of fill age were investigated by performing field and laboratory studies on the Suzhou landfill in China. The field study included sampling from five boreholes advanced to the bottom of the landfill, cone penetration tests and monitoring of pore fluid pressures. Twenty-six borehole samples representative of different fill ages (0 to 13 years) were used to perform drained triaxial compression tests. The field and laboratory study showed that the waste body in the landfill can be sub-divided into several strata corresponding to different ranges of fill age. Each of the waste strata has individual composition and shear strength characteristics. The triaxial test results showed that the MSW samples exhibited a strain-hardening and contractive behavior. As the fill age of the waste increased from 1.7 years to 11 years, the cohesion mobilized at a strain level of 10% was found to decrease from 23.3 kPa to 0 kPa, and the mobilized friction angle at the same strain level increasing from 9.9° to 26°. For a confinement stress level greater than 50 kPa, the shear strength of the recently-placed MSW seemed to be lower than that of the older MSW. This behavior was consistent with the cone penetration test results. The field measurement of pore pressures revealed a perched leachate mound above an intermediate cover of soils and a substantial leachate mound near the bottom of the landfill. The measurements of shear strength properties and pore pressures were utilized to assess the slope stability of the Suzhou landfill.     

Assessment of disaster resilience capacity of hillslope communities with high risk for geological hazards

This study presents a novel preparedness assessment method for assessing hazard mitigation and environmental planning of hillslope communities. A professional questionnaire was utilized to weight each indicator. Communities in Hsinchu, Taichung and Nantou counties with debris flow hazards were taken as study samples. Debris flow risk and landslide susceptibility for each community were determined using Geographic Information System (GIS) technology and logistic regression analysis. Thus, a novel risk assessment method for evaluating disaster resilience capacity of hillslope communities was established. This method was then applied to assess casualties caused by Typhoon Herb in 1996 and Typhoon Mindulle in 2004. Additionally, the analytical results generated by this assessment method were discussed with the aim of developing references for implementation of risk analysis, increasing the effectiveness of disaster mitigation, and reducing future loss of life and property.     

Silicon isotope fractionation in bamboo and its significance to the biogeochemical cycle of silicon

A systematic investigation on silica contents and silicon isotope compositions of bamboos was undertaken. Seven bamboo plants and related soils were collected from seven locations in China. The roots, stem, branch and leaves for each plant were sampled and their silica contents and silicon isotope compositions were determined. The silica contents and silicon isotope compositions of bulk and water-soluble fraction of soils were also measured. The silica contents of studied bamboo organs vary from 0.30% to 9.95%. Within bamboo plant the silica contents show an increasing trend from stem, through branch, to leaves. In bamboo roots the silica is exclusively in the endodermis cells, but in stem, branch and leaves, the silica is accumulated mainly in epidermal cells. The silicon isotope compositions of bamboos exhibit significant variation, from −2.3‰ to 1.8‰, and large and systematic silicon isotope fractionation was observed within each bamboo. The δ³⁰Si values decrease from roots to stem, but then increase from stem, through branch, to leaves. The ranges of δ³⁰Si values within each bamboo vary from 1.0‰ to 3.3‰. Considering the total range of silicon isotope composition in terrestrial samples is only 7‰, the observed silicon isotope variation in single bamboo is significant and remarkable. This kind of silicon isotope variation might be caused by isotope fractionation in a Rayleigh process when SiO₂ precipitated in stem, branches and leaves gradually from plant fluid. In this process the Si isotope fractionation factor between dissolved Si and precipitated Si in bamboo (α_pre-sol) is estimated to be 0.9981. However, other factors should be considered to explain the decrease of δ³⁰Si value from roots to stem, including larger ratio of dissolved H₄SiO₄ to precipitated SiO₂ in roots than in stem. There is a positive correlation between the δ³⁰Si values of water-soluble fractions in soils and those of bulk bamboos, indicating that the dissolved silicon in pore water and phytoliths in soil is the direct sources of silicon taken up by bamboo roots. A biochemical silicon isotope fractionation exists in process of silicon uptake by bamboo roots. Its silicon isotope fractionation factor (α_bam-wa) is estimated to be 0.9988. Considering the distribution patterns of SiO₂ contents and δ³⁰Si values among different bamboo organs, evapotranspiration may be the driving force for an upward flow of a silicon-bearing fluid and silica precipitation. Passive silicon uptake and transportation may be important for bamboo, although the role of active uptake of silicic acid by roots may not be neglected. The samples with relatively high δ³⁰Si values all grew in soils showing high content of organic materials. In contrast, the samples with relatively low δ³⁰Si values all grew in soil showing low content of organic materials. The silicon isotope composition of bamboo may reflect the local soil type and growth conditions. Our study suggests that bamboos may play an important role in global silicon cycle.     

Soil n-alkane δD vs. altitude gradients along Mount Gongga, China

The altitude effect on the isotopic composition of precipitation and its application to paleoelevation reconstruction using authigenic or pedogenic minerals have been intensively studied. However, there are still no studies on variations in biomarker δD along altitude transects to investigate its potential as a paleoelevation indicator, although it has been observed that δD of higher plant lipid may record changes in precipitation δD (δD_p). Here, we present δD values of higher plant-derived C₂₇, C₂₉, and C₃₁n-alkanes from surface soil along the eastern slope of Mount Gongga, China with great changes in physical variables and vegetation over a range from 1000 to 4000 m above sea level. The weighted-mean δD values of these n-alkanes (δD_wax) show significant linear correlations with predicted δD_p values (R² = 0.76) with an apparent isotopic enrichment (ε_wax-p) of −137 ± 9‰, indicating that soil δD_wax values track overall δD_p variation along the entire altitudinal transect. Leaf δD_wax is also highly correlated with mountain altitude by a significant quadratic relationship (R² = 0.80). Evapotranspiration is found declining with altitude, potentially lowering δD_wax values at higher elevations. However, this evapotranspiration effect is believed to be largely compensated by the opposing effect of vegetation changes, resulting in less varied ε_wax-p values over the slope transect. This study therefore confirms the potential of using leaf δD_wax to infer paleoelevations, and more generally, to infer the δD of precipitation.     

Church-based social capital, networks and geographical scale: Katrina evacuation, relocation, and recovery in a New Orleans Vietnamese American community

This research examines the role of social capital and networks to explain the evacuation, relocation, and recovery experiences of a Vietnamese American community in New Orleans, Louisiana in the aftermath of Hurricane Katrina. As the single largest community institution, the parish church’s complex bonding and bridging social capital and networks proved particularly critical in part because of its historically based ontological security. The process of evacuation, but especially relocation and recovery, was dependent on deploying co-ethnic social capital and networks at a variety of geographical scales. Beyond the local or community scale, extra-local, regional, and national scales of social capital and networks reproduced a spatially redefined Vietnamese American community. Part of the recovery process included constructing discursive place-based collective-action frames to successfully contest a nearby landfill that in turn engendered social capital and networks crossing ethnic boundaries to include the extra-local African American community. Engaging social capital and networks beyond the local geographical scale cultivated a Vietnamese American community with an emergent post-Katrina cultural and political identity.     

Sorption of Ni on Na-rectorite studied by batch and spectroscopy methods

Sorption of Ni²⁺ on Na-rectorite as a function of contact time, temperature, pH and fulvic acid (FA)/humic acid (HA) was studied under ambient conditions. A pseudo-second-order rate equation was used to simulate the kinetic sorption. The removal of Ni²⁺ increased with increasing pH. The presence of FA/HA enhanced the sorption of Ni²⁺ at low pH values, whereas no drastic effect of FA/HA on Ni²⁺ uptake to rectorite was found at high pH values. The diffuse layer model (DLM) fitted the experimental data of Ni²⁺ sorption in the absence and presence of FA/HA very well with the aid of FITEQL 3.2. The Langmuir, Freundlich and Dubinin–Radushkevich (D–R) models were used to simulate the sorption isotherms of Ni²⁺ at different temperatures. The thermodynamic data (ΔH⁰, ΔS⁰, ΔG⁰) were calculated from the temperature dependent sorption isotherms and the results suggested that the sorption process of Ni²⁺ on rectorite was spontaneous and endothermic. The sorption and species of Ni²⁺ on rectorite in the presence and absence of FA/HA was also investigated and characterized by XPS. The spectroscopic analysis indicated no drastic structural changes of Na-rectorite and the sorption of Ni²⁺ mainly occurred on the surface and at the edge position of Na-rectorite.     

Numerical estimation of REV and permeability tensor for fractured rock masses by composite element method

The Monte Carlo method is used to generate parent stochastic discrete fracture network, from which a series of fractured rock samples of different sizes and orientations are extracted. The fracture network combined with a regular grid forms composite element mesh of the fractured rock sample, in which each composite element is composed of sub‐elements incised by fracture segments. The composite element method (CEM) for the seepage is implemented to obtain the nodal hydraulic potential as well as the seepage flow rates through the fractured rock samples. The application of CEM enables a large quantity of stochastic tests for the fractured rock samples because the pre‐process is facilitated greatly. By changing the sizes and orientations of the samples, the analysis of the seepage characteristics is realized to evaluate the variation of the permeability components, the existence of the permeability tensor and the representative element volume. The feasibility and effectiveness are illustrated in a numerical example. Copyright © 2008 John Wiley & Sons, Ltd.